rate of loading
推荐文章
释义
载荷速率，载重率，装载速度；
权威例句
Downhole flow measurement in a wellRelationship between quadriceps strength and rate of loading during gait in women
Crack propagation in an elastic solid subjected to general loading—II. Non-uniform rate of extension
Characterization, modelling and simulation of deformation and fracture behaviour of the light-weight wrought alloys under high strai...
The effect of rate of loading upon the static and fatigue strengths of plain concrete in compression : 10F, 1T, 6R. MAG. CONCRETE RE...
The effect of rate of loading upon the static and fatigue strengths of plain concrete in compression*
Mikesky, A. E., Meyer, A. & Thompson, K. L. Relationship between quadriceps strength and rate of loading during gait in women. J. Or...
Subtalar Pronation Does Not Influence Impact Forces or Rate of Loading During a Single-Leg Landing
The Influence of Rate of loading and Material Variability on the Fatigue Characteristics of Concrete
Rate-of-Loading Effects on Pseudodynamic Tests
1. If patients do experience a decreased ROM as a consequence of impingement, then subluxation and edge loading may occur, which can lead to a higher wear rate and early failure.
如果病人感觉到降低活动度是撞击的结果，然后半脱位和边缘负荷可能发生，这能导致更高的磨损率和早期的失败。
youdao
2. If the failure is defined as the final fracture of a component, then both S-N curves and crack growth rate curves reflect the fundamental material behavior under fatigue loading.
如果都把一个构件的最终断裂作为疲劳破坏的定义，则S - N曲线和裂纹扩展率曲线均是反映金属在疲劳载荷作用下的基本材料特性。
youdao
3. Do not exceed loading rate of 200tonnes per hour.
装货速率不要超过每小时200吨。
youdao
4. Tibial plateau fracture is intra-articular fracture of weight loading joint with high incidence rate.
胫骨平台骨折是负重关节的关节骨折，发病率较高，对康复的要求也很高。
youdao
5. This provides a feasible testing method for studying the behavior and constitutive relation of rock failure with medium stain rate under dynamical loading or static and dynamical combination loading.
为研究岩石在中等应变速率下的动态加载或动静组合加载的破坏特性及本构关系提供了一种可行的试验方法。
youdao
6. The rate of losing water decreased with the loading density increasing.
而且随着装烟密度的增加，失水速率减小。
youdao
7. By controlling ship floating state, the rate and ability of loading or discharging ballast water can be enhanced to ensure the adaptation of ballast water to cargo operation during the cargo loading.
通过控制船舶的浮态提高船舶压载水的速率及排放能力，保证货物装载过程中压载水与货物操作相适应。
youdao
8. The computing method and its application of the reduction rate of the load with diagonal and symmetrical loading are discussed and given.
并讨论了斜对角装载、斜对称装载产生的减载率的近似计算方法及其应用。
youdao
9. Study of fatigue crack growth rate and fatigue life calculation under random loading is very important for the reliable life prediction of engineering structures.
变化载荷作用下裂纹扩展律和疲劳寿命的计算对工程结构的寿命的可靠预测是十分重要的。
youdao
10. Moreover, the increase of hydraulic loading will lead to the decline of the removal rate of organics and ammonia nitrogen.
此外，在低温条件下提高水力负荷会导致对有机物和氨氮去除率的下降。
youdao
11. For the UPR with greater brittleness, the brittle-tough transition was observed only when the toughness of the resin was characterized by fracture toughness at a slower loading rate.
对于脆性较大的UPR，只有在采用加载速度较慢的断裂韧性来表征其韧性时，方能观察到这一脆韧转变现象。
youdao
12. The equations of loading and bounding surfaces are described in strain-energy release rate.
加载面、边界面方程均以损伤能量释放率表示。
youdao
13. The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.
研究了变形速度，试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。
youdao
14. So the regeneration of high loading rate sludge was noneffective.
对于高负荷污泥的再生是无效的。
youdao
15. Feeding rate, the kiln incline degree and the kiln rolling speed are adjusted to study the changes of particles mean residence time (MRT), mean volume flow (MVF) and loading rate in the kiln.
通过改变给料率、回转窑倾角、回转窑转速来考察它们对物料在回转窑内的平均停留时间(MRT)、平均体积流率(MVF)、填充率的影响。
youdao
16. By means of parametric analysis, the effect of loading rate and anchor embedment on suction force and limit value of total tension resistance are discussed.
进而通过变动参数分析，讨论加载速率和埋深对吸力和总抗拉力极限值的影响，并给出排水和不排水加载条件对应的临界加载速率。
youdao
17. Shortterm shear behaviors depend on loading rate and test temperature while the shapes of the shear creep curve and the creep lives depend on test temperature and stress.
瞬时剪切行为存在加载速率、温度相关性；剪切蠕变曲线形状和蠕变寿命与温度及应力大小有关。
youdao
18. Two essential operational parameters of (ASBR) - fill time and organic loading rate were discussed for their effects on the process performance through orthogonal tests.
通过正交试验，探讨了A SBR工艺最为重要的两个操作参数即充水时间和负荷率对ASBR工艺过程的影响。
youdao
19. The rate of loading should be 300 metric tons per workable hatch.
每个可使用的舱口的装货率应为300公吨。
youdao
20. The experimental investigation of the effect of loading rate on the tensile properties of PC/ABS and the analysis of the test results has been given in the paper.
从简单的拉伸试验着手，研究了应变加载速率对PC/ABS 高分子材料拉伸性能的影响，并对试验结果进行了详细分析。
youdao
21. The cabinet can reduce power cut off range and increase job rate of mining and loading equipments.
采用本开关柜可缩小矿山停电范围，减少停电时间，提高设备作业率。
youdao
22. The effects of stirred velocity, chlorine flow rate, air auxiliary flow rate, solids loading, mean particle diameter and reaction temperature on global process rate are investigated and analyzed.
考察了搅拌速度、氯气流量、辅助空气流量、固体联二脲浓度、粒度及反应温度对过程速率的影响。 分析了影响过程速率的主要因素。
youdao
23. The absorbed energy property and deformation characteristic of magnesium alloy under high strain rate loading are described.
介绍了高应变率载荷条件下镁合金的吸能特性及变形特征；
youdao
24. And may decrement rock-loading of driving circulate, quicken driving rate.
从而可缩短掘进循环中的装岩时间，加快掘进速度。
youdao
25. The influence of chamber pressure, gas flow rate and RF power on micro loading effect in reactive ion etch of silicon dioxide is researched.
对二氧化硅反应离子刻蚀中反应室压力，刻蚀气体流量和射频功率等因素对刻蚀速率和刻蚀均匀性的影响进行了研究。
youdao
26. The effect of loading rate on concrete splitting tensile strength for different lateral stresses is studied.
系统地探讨了有侧应力作用时，混凝土在不同加载速率下的劈拉强度规律。
youdao
27. The equations of loading surface and boundary surface are expressed in strain-energy releasing rate.
加载面、边界面方程均以损伤能量释放率表示。
youdao
28. The design method was implying the new concept of Loading Rate both on fill phase and react phase.
该设计方法引入了“进水期污泥负荷”和“反应期污泥负荷”两个概念。
youdao
29. The design method was implying the new concept of Loading Rate both on fill phase and react phase.
该设计方法引入了“进水期污泥负荷”和“反应期污泥负荷”两个概念。
youdao
rate of loading
