gear ratio

释义
齿轮齿数比;速比;传动比;
英英释义
Gear ratio
The gear ratio of a gear train, also known as its speed ratio, is the ratio of the angular velocity of the input gear to the angular velocity of the output gear.J.
以上来源于:Wikipedia
双语例句
用作名词(n.)
To perform the gear ratios synthesis, the exact solution of gear ratios is obtained from the kinematic equation and the geometric constraint of each basic EGM.
运动综合时,精确的齿数比可以从每一个基本周转轮系的运动学方程和几何约束方程中求出。
Only transformer coupling can contribute to the voltage gain of an amplifier by virtue of a stepup turns ratio.
只有放大器耦合方能通过开压匝数比提高变压器电压增益。
权威例句
Gear ratioTransmission assembly with four planetary gear sets providing nine forward and one reverse gear ratio
Improvement in Driver-Vehicle System Performance by Varying Steering Gain with Vehicle Speed and Steering Angle: VGS (Variable Gear-...
Muscle fiber angle, segment bulging and architectural gear ratio in segmented musculature.
Theoretical and experimental results of an electrostatic micro motor with large gear ratio fabricated by the LIGA process
Geometry design, three-dimensional modeling and kinematic analysis of orthogonal fluctuating gear ratio face gear drive
Effects of backrest positioning and gear ratio on nondisabled subjects' handcycling sprinting performance and kinematics
Kinematic analysis of handbike propulsion in various gear ratios: implications for joint pain
Gear ratio optimization and shift control of 2-speed I-AMT in electric vehicle
Handcycling: different modes and gear ratios.
1. These refer to the gear ratio in the differential.
在差速器中,这些都是指减速比。
youdao
2. Some cars have variable-ratio steering, which uses a rack-and-pinion gear set that has a different tooth pitch (number of teeth per inch) in the center than it has on the outside.
有些车的转向系角传动比是可变的,这种转向器采用齿轮齿条式,它在中间而不是外部,有不同的齿密度(每寸齿数)。
youdao
3. Gears of first stage are changeable so that the operator can change the gear ratio based on current field condition.
第一级传动齿可变,驾驶员可根据电流与磁场情况来改变齿数比。
youdao
4. For instance, in a device with two gears, if one gear is twice the size of the other, the ratio would be 2:1.
例如,两个齿轮的传动机构中,如果一齿轮的尺寸是另一齿轮的两倍,那么传动比就是2:1。
youdao
5. Line recovery (the amount of line recovered with each turn of the handle) is related to gear ratio, but it's also affected by the size of the reel's spool.
收线量(每摇动一圈手把所收回的线的长度)和速比相关,也同时和线杯的大小有关。
youdao
6. This paper brings out feasibility and applicability to make change drive of double step sliding gear by moving one gear width along axis under conditions of Corresponding ratio of gear.
本文阐述了双联滑移齿轮在适当传动出情况下,轴向移动一个齿轮宽度就可以进行变速的可行性及适用场合。
youdao
7. We have used the CYLINDRICAL gear transmission ratio of small, large, heavy structure.
我们常用的圆柱齿轮传动比小,体积大、结构笨重。
youdao
8. A-operator method (AOM) is used to study the influence of the speed ratio and time varying meshing stiffness on rattling threshold speed of the gear system.
用算符分解算法(AOM)得到了系统的近似解析解,并研究了传动比和时变啮合刚度对拍击门槛转速的影响。
youdao
9. More torque can be sent to the wheels in first gear than in fifth gear because first gear has a larger gear-ratio by which to multiply the torque.
一档变速传给车轮的转矩比五档传出的转矩大,因为一档变速有大的传动比,而大的降速比则加大了驱动力矩。
youdao
10. The relative sliding ratio formulas of an involute internal spur gear pair are developed.
推导了渐开线内齿轮副相对滑动率的计算公式。
youdao
11. The clutch is also used to disengage the engine from the drive train whenever the gears in the transmission are being shifted from gear ratio to another.
此外,在改变变速器齿轮的传送比时(换档时),离合器也被用于切断传动系与发动机之间的连接。
youdao
12. Then the locus curves of one point in the geared five-bar were studied with the change of the gear ratio, the phase Angle, the bar length and the Angle between two bars.
然后,针对能够整周转动的齿轮—五杆机构,研究了其上的一点在齿轮机构的传动比、初始相位角、杆长以及两杆之间的夹角变化时的轨迹曲线以及速度和加速度曲线的情况。
youdao
13. When the open-loop gain of servo system is determined, the selection of DAC resolution and gear ratio is restricted each other and should be paid much attention in the design of servo system.
由于DAC和齿轮减速比都影响着伺服系统的开环增益,当系统开环增益一定时,DAC位数的实际作用和减速比的选择相互限制,在设计雷达伺服系统中需注意。
youdao
14. The conjugate principle of the variable ratio gear with constant center distance and constant contact Angle has been analysed.
研究了定中心距、定啮合角变速比齿轮的啮合原理。
youdao
15. The gear sector of variable transmission ratio in automobile steering mechanism is a variable module non-circular gear.
变传动比汽车转向器齿扇是变模数的非圆齿轮。
youdao
16. The ratio is determined by the distances from the center of the gear to the point of contact.
传动比是由两轮的中心到啮合点的距离所决定的。
youdao
17. It has an aggressive 4.07:1 first gear ratio that delivers strong launches, but also provides tall overdrive ratios that decrease engine RPM and provide better fuel efficiency.
它有一个积极的4.07:1第一齿轮比,提供强大的发射,而且还提供高过载率的降低发动机转速,并提供更好的燃油效率。
youdao
18. On load sharing condition, the planet-gear shows several advantages such as great transmission ratio, compact structure, high efficiency, large load capacity and drive steady.
行星齿轮传动只有在载荷分配均匀情况下才能发挥传动比大、结构紧凑、效率高、承载能力大、传动平稳等优点。
youdao
19. Propeller slip calculator for powerboats Please use this calculator to figure out all parameters in regard to pitch, gear ratio, RPM, speed and slip.
机动船的螺旋桨滑计算器请使用这个计算器计算出所有参数间距,齿轮比,转速,速度和防滑方面。
youdao
20. The pump flow evenly, smooth operation, low noise, high power operation pressure and volume ratio gear pumps, gear pumps than messy layout.
这种泵流量均匀、作业平稳、噪音小、作业压力和容积功率比齿轮泵高、布局比齿轮泵杂乱。
youdao
21. The design calculation process and related process methods for transmission ratio, gear transmission, end mechanic sealing and eccentric short roller bearing used for 180 turbine drill are described.
叙述了180涡轮钻具用减速器的传动比,齿轮传动,端面机械密封和偏心短圆柱轴承的设计计算过程和有关处理办法。
youdao
22. After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
在获得齿轮内啮合传动的齿侧间隙计算公式以后,结合齿对刚度的计算公式,推导出齿轮内啮合传动的加载重合度及载荷修正系数。
youdao
23. In this paper, the meshing theory of rack and pinion steering gear with variable ratio is studied systematically.
对汽车变速比齿轮齿条式转向器的啮合原理进行了系统研究。
youdao
24. Pressed and welded steel banjo housing, single reduction, hypoid gear, ratio 6.33:1.
冲压,焊接钢班卓琴住房,单减少,双曲面齿轮,比6.33:1。
youdao
25. The relationship between the diameter of the gear attached to the pedals and the one attached to the wheels is called the gear ratio.
与自行车脚蹬相连的传动装置的直径与和车轮相连一起的传动装置的直径的比称为传动比。
youdao
26. When the total cycle pump gear shift operation, the flow of the slip road ratio unchanged.
当总循环泵变速运行时,各个支路的流量分配比例保持不变。
youdao
27. In a manual transmission, gears slide along shafts as you move the shift lever from one position to another, engaging various sized gears as required in order to provide the correct gear ratio,.
在一个手动变速器里,当你操纵换挡杆从一个档位到另一个档位时,齿轮沿轴向滑动,使大小不同的齿轮进行啮合从而满足不同的传动比的需要。
youdao
28. In a manual transmission, gears slide along shafts as you move the shift lever from one position to another, engaging various sized gears as required in order to provide the correct gear ratio,.
在一个手动变速器里,当你操纵换挡杆从一个档位到另一个档位时,齿轮沿轴向滑动,使大小不同的齿轮进行啮合从而满足不同的传动比的需要。
youdao
gear ratio




