bushing
推荐文章
n. [电] 套管；轴衬
n.
轴衬；套管；使不同口径的管子接合在一起的转接器 ；欺诈性买卖
英英释义
bushing[ 'buʃiŋ ]
n.
an insulating liner in an opening through which conductors pass
a cylindrical metal lining used to reduce friction
同义词：cylindrical lining
词组短语
george bush乔治·布什（美国前总统）
around the bush拐弯抹角；说话绕圈子
beat about the bush旁敲侧击；转弯抹角
bearing bush轴瓦，轴承衬
beat around the bush旁敲侧击；说话绕圈子
bush bearing衬套轴承；滑动轴承
drill bush钻套
copper bush铜套；铜轴套；铜衬套
双语例句
用作名词(n.)
Determine the proper bushing length from the thickness of the center member to be inserted between the friction facings.
由设于摩擦板间的中心构件厚度，决定正确的轴衬长度。
Grease from a standard grease fitting is distributed to the shaft through a groove in the outside diameter of the bearing and from radial holes in the bushing's well.
从标准润滑油嘴注入的润滑油通过轴承外径的环形槽分流到阀轴上，并且从径向孔流入轴衬壁上。
权威例句
Long-term effects of p-chloroamphetamine and related drugs on central serotonergic mechanisms.FLUOROPOLYMER BUSHINGS
Rationally Derived Three-Parameter Models for Elastomeric Suspension Bushings: Theory and Experiment
The Numerical Analysis of Axially Loaded Elastomeric Bushing
Detecting the HV-bushing Oil Leakage Defect of the 500 kV Transformer Using the Infrared Detection Technology
Functional Analysis of Bushing in Four-Link Suspension on K&C Characteristics Using Multibody Dynamics Method
The Development of Gas Bushing for 25.8㎸/2000A GCB
Industrial truck i.e. counterbalance fork-lift truck, has single-side opened cable holders in which cable connection is insertable, ...
Milking tube coupling device for milking system, has insertion part with connection, by which tube is received in liquid-tight manne...
Status of the ITER heating neutral beam system
bushing (n.)
"metal sleeve fitted into a machine or hole," 1839, from gerundive of bush "metal lining of the axle hole of a wheel or touch hole of a gun" (1560s), from Middle Dutch busse "box" (cognate with the second element in blunderbuss).
1. See attached figure for installation dimension of bushing.
套管外形及安装尺寸见附图。
wzhxkg.vsp.windmsn.com
2. Oil filled bushing should have plugs for test of power factor.
充油套管应带有用于进行功率因数试验的接插头。
www.youdict.com
3. Metal switchboard on the oil-filled bushing should be in termination under oil .
在充油套管上，金属配电板在油下进行端接。
zuci.chaziwang.com
4. The transformer shall employ pure porcelain bushing.
变压器采用纯瓷套管。
www.websaru.net
5. In this experiment, the flame stability under large bushing is better than under small bushing.
在实验中，大套管实验工况的火焰稳定性比小套管要好。
zuci.chaziwang.com
6. This paper mainly described the classification of bushing and insulation design, and a brief introduction to the bushing of the partial discharge on-line monitoring.
本文主要讲述套管的分类以及绝缘设计，并对套管局部放电的在线监测进行简单介绍。
m.xielw.cn
7. Based on worksite practice, the paper introduces Cleaning and Overhaul Technology of the chock, bushing, sleeve which are the key parts in the oil film bearing.
本文以现场实际经验为基础，重点介绍了轴承座、锥套和衬套这三个油膜轴承中关键件的清洗和检修技术。
www.xjishu.com
8. Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承：曲轴上的导向轴承一般或者是轴瓦，或者是球轴承。
www.dictall.com
9. In some instances the reinforcement can be achieved using small aluminum tube as bushing.
在一些例中钢筋能被达成以小的铝管作为桥衬。
www.tech-domain.com
10. Tighten leaf spring press until bushing is extracted from leaf spring.
上紧叶片弹簧加压机直到衬套被拔出叶片弹簧。
www.dictall.com
11. Pump wear parts are mainly drive shaft and bushing, passive gear center hole and shaft pin, pump shell lumen and gear, gear face and pump cover, etc.
齿轮泵的磨损部位主要有主动轴与衬套、被动齿轮中心孔与轴销、泵壳内腔与齿轮、齿轮端面与泵盖等。
www.btydby.com
12. Bushings must be removed to permit a thorough inspection of the base metal and to avoid bushing-to-bore interface degradation during bake cycles.
必须拆下衬套，对本体金属进行彻底的检查，防止在烘焙过程中衬套与孔之间的表面失效。
zuci.chaziwang.com
13. Master cylinder bushing at the clutch pedal.
离合器踏板处的总泵衬套。
dict.cn
14. This procedure MUST be followed when installing a new bushing or seizure to shaft may occur.
安装新衬套时，必须遵循本程序，否则驱动轴可能滞塞。
zuci.chaziwang.com
15. Align adapter bushing or gear operator (3) bore with valve stem (5).
用阀门的阀杆（5）对准适配器衬套或持论操作机构（3）镗孔。
www.114zuowen.com
16. The interference fits of bushing bearing has been calculated by finite element method based on ANSYS.
以ANSYS为平台，对衬套与轴承座的过盈联接进行了有限元计算。
zuci.chaziwang.com
17. Shipbuilding. kingston valves. stuffing box, gland and bushing.
造船工业。 “金士顿”阀门。密封垫压盖和套。
dict.site
18. Meanwhile, the influence to the central field brought with the shielding bushing is discussed.
同时，还研究了探测线圈屏蔽套筒给中心磁场及测量信号带来的影响。
zuci.chaziwang.com
19. The adapter bushing and key may be different from illustration shown.
适配器衬套和销键可能与图示不同。
www.youdict.com
20. Self-lubricated bushing is very popular in western countries.
自动润滑轴套在西方国家很流行。
www.fq51.cn
21. Blind-hole lower bushing prevents leakage.
“盲孔”下部衬垫能够防止泄漏。
www.dictall.com
22. The rotating slip ring is insulated from the shaft by a laminated plastic bushing .
旋转滑环是用片状塑料衬套与轴绝缘的。
www.youdict.com
23. Place Taper-lock Bushing and Timing Belt Pulley on the transmission shaft.
将锥面紧固套与同步带轮装在传动轮上。
www.pdl88.com
24. Connection of lead and bushing shall be tight and correct, bushing should be in good condition.
引出线与套管的连接应牢靠，接线正确。套管应完好无损。
www.nfust.com
25. Tighten leaf spring press until bushing flange bottoms solidly against leaf spring eye.
上紧叶片弹簧加压机直到衬套凸缘的底部扎实地扺住叶片弹簧的孔眼。
www.xjishu.com
26. High-quality porcelain bushing can provide low insertion loss and durability;
高质量的陶瓷套管提供低插入损耗和耐久性；
www.hongtunet.com
27. File off both bores to the hexagon of the insertion bushing using a needle-point file.
用细锉将两个孔锉成镶入衬套的六边形。
www.websaru.com
28. The paper recommends the appearance of the water cooled bushing corroded for mains frenquency induction melting furnace.
介绍熔化炉的水冷套发生腐蚀的现象，分析了发生腐蚀的原因，提出了水冷套在制作、安装等方面的改进措施。
www.xjishu.com
29. The piston bushing materials is the key problem of automobile engine technology.
活塞衬套材料是发展汽车发动机技术的关键问题。
www.dictall.com
30. The piston bushing materials is the key problem of automobile engine technology.
活塞衬套材料是发展汽车发动机技术的关键问题。
www.dictall.com
31. Cell connectors and terminal post burning must be done in such a manner that there is complete fusion of the post strap top and the cover lead bushing with the connector ring or terminal post.
连接条和接线柱的焊接必须使极柱顶部和盖子的铅衬套与连接条环口或接线柱完全熔焊牢固。
-- 来源 -- 英汉 - 辞典例句
32. The rotating slipring is insulated from the shaft by a laminated plastic bushing.
旋转滑环是用片状塑料衬套与轴绝缘的。
-- 来源 -- 英汉 - 辞典例句
33. stripper Bushing
脱模衬套
-- 来源 -- 英汉 - 翻译样例 - 产品
34. throughput of bushing
坩埚出料量
-- 来源 -- 英汉 - 短句参考
35. Blind-hole lower bushing prevents leakage.
"盲孔"下部衬垫能够防止泄漏。
-- 来源 -- 英汉 - 翻译样例 - 产品
36. Distributor Driveshaft Bushing Installation
分电器驱动轴衬套安装
-- 来源 -- 英汉 - 翻译参考
37. Bushing Retainer To Suspension Cradle Attaching Bolts
衬套扣环与悬吊架接合螺栓
-- 来源 -- 英汉 - 翻译参考
38. `The glass in the form of marbles or batch is introduced into the bushing.
把玻璃球或配合料加到坩埚中。
-- 来源 -- 英汉 - 辞典例句
39. Bushing Retainer To Axle Attaching Bolts
衬套扣环与车轴接合螺栓
-- 来源 -- 英汉 - 翻译参考
40. In this state of turmoil she drove into Bushing Park and saw Victor Henry standing at the bus stop.
她就在这种七上八下的心情中驾车驶进了布希公园，看见维克多·亨利站在车站上。
-- 来源 -- 英汉 - 辞典例句
bushing
