decarburization
n.
脱碳；
英英释义
Decarburization
Decarburization (or decarbonization) is the process opposite to carburization, namely the reduction of carbon content.
以上来源于:Wikipedia
双语例句
用作名词(n.)
Is hardness tested on a surface that has been ground to remove decarburization?
硬度测试是不是在磨去脱碳层的表面上进行？
Results show that the crack is mainly intergranular and there is no decarburization and oxidation at the edge of the crack.
根据齿座表面裂纹主要呈沿晶扩展，裂纹两侧无脱碳和氧化现象，认为该裂纹为淬火裂纹。
权威例句
On the decarburization of steel and related questionsFactors controlling decarburization in HVOF sprayed nano-WC/Co hardcoatings
Fluid Flow in Ladle and Its Effect on Decarburization Rate in RH Degasser
Off-line measurement of decarburization of steels using a multifrequency electromagnetic sensor
Method for minimizing decarburization and other high temperature oxygen reactions in a plasma sprayed material
Effect of Refining Conditions for Ultra Low Carbon Steel on Decarburization Reaction in RH Degasser.
Processing–structure–property correlation and decarburization phenomenon in detonation sprayed WC–12Co coatings
Mathematical modeling of the argon-oxygen decarburization refining process of stainless steel: Part I. Mathematical model of the pro...
Laser-induced breakdown spectroscopy applications in the steel industry: Rapid analysis of segregation and decarburization ☆
Laser induced breakdown spectroscopy applications in the steel industry: Rapid analysis of segregation and decarburization, Spectroc...
1. The fine carbon additive in feedstock powders not only increases the hardness of the coatings but also decreases the degree of decarburization.
喷涂粉末中加入细碳粉不仅有利于提高涂层的硬度，而且可减小涂层脱碳程度。
dict.cnki.net
2. It analyzed main factors of arising spectrum analysis error which including specimen decarburization layer depth, surface roughness, describing, etc.
分析了引起光谱分析误差的主要因素，如试样脱碳层深度、表面粗糙度、描迹等。
www.dictall.com
3. The decarburization rate in bath was proportional to the intensity of oxygen supply and the utilization ratio of oxygen was enhanced with the oxygen pressure rising.
在高碳范围内熔池脱碳反应速度与供氧强度和氧气利用率成正比，而提高吹氧压力可以提高氧气利用率。
dict.cnki.net
4. The decarburization rate in bath is proportional to the intensity of oxygen supply and the utilization ratio of oxygen depends on the oxygen pressure.
在高碳范围内熔池脱碳反应速度与供氧强度和氧气利用率成正比。 而提高吹氧压力可以提高氧气利用率。
dict.cnki.net
5. Quenching crack propagation characteristics of the organizations on both sides without decarburization phenomenon significant difference between crack and materials and forging cracks.
淬火裂纹的组织特征是裂纹两侧无脱碳现象，明显区别与锻造裂纹和材料裂纹。
blog.sina.com.cn
6. The result shows that the decarburization depth increases with the increase in temperature and holding time for the two steels.
结果表明，两种弹簧钢的脱碳深度随提高加热温度和增加加热时间增大。
www.dictall.com
7. Therefore, the treated surface clean, no decarburization, surface uniformity, distortion, and high quality.
因此，处理后的工件表面光洁、无脱碳、表面均匀、变形小、质量高。
www.chinafastener.net
8. Rough machining shall be performed so as to remove all mill decarburization from the raw material surface.
必须进行粗加工以去除原材料轧制过程中的表面氧化脱碳。
www.jxcad.com.cn
9. The results show that the steel with 0.60%C possesses higher strength and hardness but lower plasticity, toughness and higher decarburization tendency.
结果表明碳、硅可提高强度、硬度。但含0.60％C的钢塑性、韧性较低，脱碳倾向也大。
dict.cnki.net
10. The research of the process in final carbon reduction efficiency, dephosphorization, decarburization, slag formation and blowing of top-bottom blowing converter are summarized and explained.
总结阐述了改造后复吹转炉终点碳氧积、脱磷、脱碳、造渣和吹炼等各项工艺的研究。
www.chemyq.com
11. The effects of various factors on decarburization of high speed tool steel annealed in bogie hearth electric furnace were investigated in this paper.
研究了高速钢轧材在台车式电阻炉中退火加热过程中，各因素对脱碳的影响。
dict.cnki.net
12. The influence of some factors on decarburization rate has been obtained, which can provide guidance for RH treatment.
利用该模型可以分析RH脱碳速度的影响因素，这对优化RH处理生产超低碳钢操作工艺提供指导。
dict.cnki.net
13. The thesis briefly expounds the equipments and the refining technology of Vacuum Oxygen Decarburization Converter(VODC).
简述了真空吹氧脱碳转炉（V O D C）的设备和精炼技术。
dict.cnki.net
14. The results show that both are caused by decarburization in heat tret - ment.
结果表明，两者均为热处理脱碳所引起。
www.youdict.com
15. Key points of smelting process, such as decarburization and Cr yield, thermal compensation, bottom blowing patterns, as well as high-efficiency desulphurization are discussed in the paper.
对转炉冶炼不锈钢时脱碳保铬、热补偿、炉底供气模式和高效脱硫技术进行了讨论。
www.chemyq.com
16. E. g. There is tight ( or thin and highly adherent) scale and decarburization, at least in certain areas.
部件上有密布（稀疏但附着力很强）鳞片和脱碳痕迹，至少在部分区域如此。
www.sharewithu.com
17. The causes of decarburization in the sintering of ferrous products using dissociated ammonia as atmosphere are analysed and some methods and routes to control decarburization are discussed.
对铁基制品采用分解氨作烧结气氛时的脱碳原因进行了分析，探讨了几种控制脱碳的方法及途径。
www.chemyq.com
18. The primary reason for lowering the fatigUe life is decarburization.
指出， 氧化脱碳引起疲劳寿命降低是该扭轴失效的主要原因。
www.chemyq.com
19. The effect of rare-earth elements to prevent oxidation and decarburization in heat treating salt bathshas been discussed.
本文就稀土对盐浴防氧化脱碳的作用进行了研究。
www.chemyq.com
20. It was observed that the decarburization reaction period in the RH could be classified into three stages in terms of the apparent reaction rate constants.
据实测结果，RH炉内脱碳反应期可根据其表现反应速率常数划分为三个阶段。
dict.cnki.net
21. For grade 1, no complete decarburization shall be present. The depth of partial decarburization at any point on the periphery shall not exceed the value in table 1.
对于等级1，没有完整的脱碳。外围任何点的部分脱碳深度不得超过表1中的数值。
www.rywen.net
22. There is tight( or thin and highly adherent ) scale and decarburization , at least in certain areas .
部件上有密布（稀疏但附着力很强）鳞片和脱碳痕迹，至少在部分区域如此。
www.yibei.com
23. The change law of depth of decarburization layer on surface of wire bar is researched based the statistics data.
根据邢钢线材表面脱碳层深度统计数据的变化规律，对脱碳层深度的变化情况进行了研究。
www.dictall.com
24. The change law of depth of decarburization layer on surface of wire bar is researched based the statistics data.
根据邢钢线材表面脱碳层深度统计数据的变化规律，对脱碳层深度的变化情况进行了研究。
www.dictall.com
25. vacuum arc decarburization process
电弧真空脱碳法
-- 来源 -- 英汉 - 翻译参考[网络]
26. surface decarburization
表面脱碳
-- 来源 -- 英汉 - 翻译参考[网络]
27. AOD (argon-oxygen decarburization)
氩氧脱碳
-- 来源 -- 英汉 - 翻译参考[网络]
28. vacuum oxygen decarburization process
真空氧气脱碳法
-- 来源 -- 英汉 - 翻译参考[网络]
29. decarburization depth
脱碳厚度
-- 来源 -- 英汉 - 翻译参考[网络]
30. argon oxygen decarburization process
氩氧脱碳法
-- 来源 -- 英汉 - 翻译参考[网络]
31. vacuum decarburization
真空脱碳
-- 来源 -- 英汉 - 翻译参考[网络]
32. vacuum oxygen decarburization converter
vod转炉
-- 来源 -- 英汉 - 翻译参考[网络]
33. argon oxygen decarburization converter
aod转炉
-- 来源 -- 英汉 - 翻译参考[网络]
34. There is tight( or thin and highly adherent) scale and decarburization, at least in certain areas.
部件上有密布（稀疏但附着力很强）鳞片和脱碳痕迹，至少在部分区域如此。
-- 来源 -- www.credit5.cn
decarburization
