abrasion hardness
释义
磨损硬度，耐磨硬度；
权威例句
abrasion hardnessCOMPOSITION FOR POLYURETHANE ELASTOMER HAVING HIGH HARDNESS AND EXCELLENT ABRASION RESISTANCE
An explanation of the relation between wear and material hardness in three-body abrasion ☆
Sensitivity of wear rates in the micro-scale abrasion test to test conditions and material hardness
Hardness, adhesion and abrasion resistance of TiO 2 films on glass ☆
Glacial erosion and bedrock properties in NW Scotland: Abrasion and plucking, hardness and joint spacing
Relations of abrasion resistance and hardness of 16Cr-3C white irons with retained austenite content
Abrasion of aluminium alloy: effect of subsurface hardness and scratch interaction simulation
In vitro abrasion resistance and hardness of glass-ionomer cements
Insight into the effect of CB loading on tension, compression, hardness and abrasion properties of SBR and NBR filled compounds
1. Advantages: good abrasion resistance, anti slip, elasticity, not easy to break, softness, good stability, extended contraction, good hardness, good bending.
优点：耐磨性佳、防滑、有弹性、不易断裂、柔软度较好、伸延性好、收缩稳定、硬度佳、弯曲性好。
youdao
2. New environment-friendly water-based varnish: excluding ketones, volatile organic compounds were very low; durability and good abrasion resistance, surface hardness of up to 2H.
新型环保水性清漆：不含酮，有机挥发物含量极低；耐久性和抗磨损性好，表面硬度可达2H。
youdao
3. It shows that the hardness of laser overlaying advance 2 times, the resistance to abrasion advances 5 times.
分析表明激光堆焊层硬度提高了2倍，耐磨性提高了5倍，耐蚀性能满足应用要求。
youdao
4. The paper analyses the foundry quality, hardness distribution, structure, abrasion mechanism and draws corresponding conclusion.
本文就其铸造质量、硬度分布、组织构成、磨损机理等作了分析并得出相应结论。
youdao
5. Emphasis is laid on the study of its corrosion resistance, hardness, wearing resistance, micromotion abrasion and micro motion fatigue properties.
着重研究了它的耐蚀性能、硬度、耐磨性和微动摩损及微动疲劳性能。
youdao
6. Bainite has higher abrasive wear resistance than tempered martensite with equal or higher hardness in hard abrasion, but in reverse in soft abrasion.
下贝氏体组织在高应力磨料磨损下比相同硬度，或稍高硬度的回火马氏体组织具有较高的耐磨性，但在低应力磨损下表现为不利的作用。
youdao
7. Hardness and abrasion resistance property are improved, the abrasion resistance property of the composite is better under the light-load condition than under the heavy-load condition.
复合材料的硬度和耐磨性均提高。轻载条件下，复合材料的耐磨性能更好。
youdao
8. By make experiment of plunger case surface abrasion hardness, in the last, adopt high strength engineering plastic to act as anti-abrasive material, make the success, get great result.
通过对柱塞的表面耐磨层进行各种试验，最后采用了高强度工程塑料进行压注试验，取得了成功，效果显著。
youdao
9. Dissolve deposited metal has low hardness and high toughness, heat corrosion resistance to impact abrasion.
溶敷金属具有低硬度高韧性，可耐热耐腐蚀耐冲击磨耗。
youdao
10. Deposited metal of martensite with high hardness, good abrasion resistance, impact resistant performance of hardness HRC55 ~ 58.
熔敷金属具有高硬度的马氏体组织，耐磨耗耐冲击性能优良，硬度HRC55 ~58。
youdao
11. Authors suggest the linear relationship between the anti-abrasion parameters consisting of the amount and distribution of carbides, abrasive surface hardness and the abrasion resistance in this paper.
本文还提出了由碳化物数量、分布、磨损面硬度等因素构成的抗磨参数与相对耐磨性的线性关系。
youdao
12. When silver alloy is used as conducting ring material, its service life is influenced by its slightly low hardness and bad abrasion resistance behavior, meanwhile it is prohibitive.
银合金作为导电环材料，因其硬度偏低、耐磨性差，影响使用寿命，同时，还存在价格昂贵的问题。
youdao
13. The hardness and abrasion resistance are higher than Swiss Kastolin Company 6715 electrode at atmospheric temperature.
常温硬度和耐磨性都高于瑞士卡斯托林公司6715焊条。
youdao
14. In the end we enumerate the studied cases of crack resistance of some high and medium hardness abrasion electrodes, which provides reference for the design and research of abrasion heap soldering.
研究了一些高、中硬度耐磨焊条的抗裂情况，为耐磨堆焊的设计和研究，提供了一定的参考依据。
youdao
15. The seal is processed in the high tech, which makes the hardness of seal face up to HRC57-60. It is endurable in high temperature, resistant in abrasion and antifriction.
采用高科技手段加工“密封副”，使密封面的硬度高达HRC57 - 60，具有耐高温、耐腐蚀、耐磨损等特性。
youdao
16. The result showed that when photo-initiator 184 and photo-initiator 1173 were mixed 2:1 by mass, the coating has high pencil hardness and excellent abrasion resistance.
结果表明，光引发剂184与光引发剂1173以质量比2：1复配使用可以很好的提高涂层的铅笔硬度以及耐磨性；
youdao
17. Thesurface hardness, corrosion resistance, abrasion resistance and light fastness as well as the surface colour of metals can be improved through oxidizing and Colouring processing.
金属材料表面经氧化和着色后，可提高其表面硬度、耐蚀性、 耐磨性、耐光性和增加表面色彩。
youdao
18. The relationship was studied among the formation condition of the amorphous state and the surface hardness, abrasion and corrosion, and the heat endurance of the amorphous state was tested.
研究激光形成非晶态的工艺条件与其表面硬度以及磨蚀及腐蚀的关系，并对非晶层的热稳定性进行测试。
youdao
19. These dispersions can be used as waterborne ultraviolet-curable coatings, the abrasion and flexibility of their film are better than that of epoxy acrylate coatings, but the hardness decrease little.
这种分散体系可作为一种紫外光固化水性涂料，其涂膜的耐磨性、柔韧性都比环氧丙烯酸酯涂膜增强，而硬度变化不大。
youdao
20. The results showed that the high carboxylated NBR featured high hardness, tensile strength and modulus, good abrasion resistance, but greater permanent set and poorer processing safety;
结果表明，高羧基丁腈橡胶具有硬度、拉伸强度和定伸应力高，耐磨性好，压缩永久变形大，加工安全性较差等特点；
youdao
21. Ceramic chemical properties of stable structure, high hardness, acid and alkali resistant to most medium corrosion, abrasion resistance and is excellent.
结构陶瓷化学性能稳定，硬度高，可耐绝大部分酸碱介质腐蚀，并且具有极好的耐磨性能。
youdao
22. The alloy plating method to get the melt method than the average of the alloy get high hardness, good abrasion resistance, such as nickel and cobalt nickel alloy-phosphorus alloys, etc.
电镀法得到的合金比一般热熔法得到的合金硬度高、耐磨性好，如镍-钴合金和镍-磷合金等。
youdao
23. So the abrasion resistance of cylinder is a matrix, hard phase, honing, graphite, and the hardness result of multiple factors.
同时缸套耐磨性是基体组织、硬质相、珩磨、石墨、硬度多种因素综合作用的结果。
youdao
24. A complete set of inks requires not only good adhesion, abrasion resistance, but also requires a relatively high hardness.
得到众多消费者的青睐，与之配套的油墨不仅需要良好的附着，耐磨性能，还要求有相对高的硬度。
youdao
25. C. Guide rail of impeller stopper adopts high hardness, good abrasion linear rails, and with small gap, high hardness ball screw lead, ensures stability and high precision for paper pushing. D.
推纸挡规导轨采用硬度高，耐磨性好的线性导轨，再配以间隙小，硬度高的滚珠丝杆，最大保证了推纸的平稳性和高精度性。
youdao
26. UV board paint thick, high hardness, abrasion, acid and alkali resistance, salt spray, impact resistant, UV cured paint has some antibacterial effects.
UV板漆面厚、硬度高，耐磨、耐酸碱、耐盐雾、耐碰撞，UV漆固化后具有一定的抗菌效果。
youdao
27. D. Guide rail of impeller stopper adopts high hardness, good abrasion linear rails, and with small gap, high hardness ball screw lead, ensures stability and high precision for paper pushing. E.
推纸挡规导轨采用硬度高，耐磨性好的线性导轨，再配以间隙小，硬度高的滚珠丝杆，最大保证了推纸的平稳性和高精度性。
youdao
28. Considering the characteristics of high degree of hardness, abrasion and high temperature of Jurassic layer, some special bits were investigated and applied.
针对侏罗系地层高硬度、强研磨性等特点，研究并试验了几种特殊类型的钻头。
youdao
29. Considering the characteristics of high degree of hardness, abrasion and high temperature of Jurassic layer, some special bits were investigated and applied.
针对侏罗系地层高硬度、强研磨性等特点，研究并试验了几种特殊类型的钻头。
youdao
abrasion hardness
